Electrifly REFLECTION Manual de instrucciones

WARRANTYGreat Planes®Model Manufacturing Co. guarantees this kit to be free from defects in both material and workmanship at the date ofpurchase.This

❏ 10.Using the same technique as you did with the horizontalstabilizer, attach four clip hinges into the rudder centeringthem properly at the location

❏ 1. Cut the wings and all four ailerons free from the foamsheet.Identify the top and bottom wings.The bottom wing hasthe aileron servo bay.Locate the

❏ 7.Glue the interplane struts into the lower wing.The redsides of the struts points outward. Try to glue the struts sothey are 90 degrees to the wing

❏ 5. Correctly position the rod supports into the wings andfuselage (test fitting the braces into the supports as needed)and gluing them permanently w

❏ 6. Cut a 45° beveled edge on the sides and tips of thefuselage braces with a sharp hobby knife. Make a shallowcut along the line shown in the pictur

❏ 1.Remove the stock servo arms from all three of the servos.❏ 2.Refer to the Kit Contentssection on page 5 and selectthe correct spline size for the

❏ 8. Insert two Z-bend clevises (A1) into the outer holes of adouble-sided servo arm that fits your servo and two Z-bendclevises into the aileron cont

❏ 4. If using the RimFire motor, mount the prop saveradapter that came with the motor. Install the propeller usingthe O-ring provided with the motor.❏

To simplify setup, the high-rate (3D) control throws for thismodel are automatically set by the geometry of the includedhardware. We do recommend, how

additional ballast required. If additional weight is required,begin by placing incrementally increasing amounts of weighton the bottom of the horizont

2INTRODUCTION ...2SAFETY PRECAUTIONS...2LIT

Keep these items away from the prop: loose clothing, shirtsleeves, ties, scarfs, long hair or loose objects such aspencils or screwdrivers that may fa

21Have your friend hold the FlatOuts R/C Universe Bipe by thecanopy.Throttle up to full power, and give the plane a gentle,underhanded toss at about a

ElectriFly FlatOuts Reflection™Go end-over-end with ease! If you’re looking for tumblingfun, the FlatOuts Reflection is your plane. Waterfalls,tumbles

23ANGLE TEMPLATESBUILDING NOTESKit Purchased Date: _______________________Where Purchased:_________________________Date Construction Started: ________

2. Build the plane according to the instructions. Do notalter or modify the model, as doing so may result in anunsafe or unflyable model.3.Use an R/C

(FUTM0042) are ideal because they meet the torque andweight requirements. Although there may be other servosthat will physically fit in the model, tho

❏ #11 blades (5-pack – HCAR0211)❏ 1-meter metric ruler (for identifying tubes and rods)❏ 5-1/2" [140 mm] Easy-Touch™bar sander (GPMR6169)with 220

6Before starting to build, take an inventory of this kit to make sure it is complete, and inspect the parts to make sure theyare of acceptable quality

Please note that all of the plastic parts used when buildingthe FlatOuts R/C Universe Bipe are identified by name andpart number, for example: Z-bend

❏ 6.Snap all the clip hinges to the carbon tube already gluedto the elevators.Push the hinges into the slots in the stabilizer.Make sure the hinges ar

❏ 3.Slide a fuselage joiner (E2), two fuselage servo mounts(F3, F4), (F3 and F4 are the same and are interchangeable),and another fuselage joiner onto