Electrifly REFLECTION Manual de instrucciones descargar pdf (Pagina 10)

❏ 10.Using the same technique as you did with the horizontal

stabilizer, attach four clip hinges into the rudder centering

them properly at the locations shown in the picture.

❏ 11. Install a Z-bend clevis (A1) into a clip hinge control

horn (C1). Clip the control horn on the right side of the

rudder between the retainer rings. Snap the rudder onto the

rudder tube and glue the control horn and hinges into

position. Be sure that the rudder moves freely.

❏ 12. Snap the tailwheel (D5) into the tailwheel bracket

(D4) and slide the tailwheel bracket onto the rudder post

tube. Glue this assembly to the rudder. Do not glue the

tailwheel bracket to the tube.

❏ 1. Locate the horizontal and vertical nose doublers

and cut them from the foam sheets. Notice that the smaller

vertical nose doublers look the same as the horizontal

doublers but have notches in the front.

❏ 2. Align the vertical doublers flush with the top and

bottom of the fuselage and glue them into position.

❏ 3.Glue the horizontal doublers to the fuselage as you did

with the vertical doublers.

Finish the Fuselage

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sin comentarios

Electrifly REFLECTION Manual de instrucciones Pagina 10